Tandberg Data T40 User Manual
Page 23
StorageLibrary Installation and User Guide
15
Figure 8. Mounting the Rack mounting Kit to a Rack
Figure 9. StorageLibrary Mounted in a Rack
shows the rails mounted in a rack with one screw M6x12
in upper hole on both left and right side. On the rear side, two screws must be used on both left and
right side. A total of six screws are used to install the rails to the rack.
Mounting the StorageLibrary to the Rack
Make sure that the screws connecting the rails to the rack are tightened properly before installing the
StorageLibrary in the rack.
Slide the StorageLibrary on the rails from the front of the rack.
Fix the StorageLibrary using two M6x12 screws in front of the rack, one on both left and right side.
The lower screw on each side connects the library to the rack, whereas the upper screw on each side
connects the left and right rail assemblies to the rack, as shown in
Figure 9. StorageLibrary Mounted
in a Rack
.
Figure 9. StorageLibrary Mounted in a Rack, Front View
Rear Rack Mount Rail
Step 5
(Screw M6x12)
Step 3
(Screw M4x12,
nut and washer)
Step 2
Step 5
(Screw M6x12)
Front Rack Mount Rail
Step 1
Holes to be used if rack
depth is shorter than the
StorageLibrary T40
Use these holes if
rack depth is equal
or longer than the
StorageLibrary T40
Step 1