Tandberg Data T40 - Manual (Page 20)

12 Installing the Library
The library will now continue its power-on sequence.
Note
Keep the transport locking screws in a safe place. You will need them to lock the
robotics if you need to return your StorageLibrary for service or repair.
Caution
The warranty does not cover damage to the library if transported without the
transport locking screws properly installed. See
Reinserting the Transport
Locking Screws for instructions on how to reinstall the transport locking screws.
Figure 4. Recommended Storage of Transport Locking Screws
If the library is to be mounted in a rack, this is the time you should mount the rack mount ears to the
library. See instructions in
Mounting the StorageLibrary in a Rack .
Mounting the StorageLibrary in a Rack
The StorageLibrary is designed for use in a 19 rack system using 4U of rack space. The length of the
power cord and the primary interface cables restrict the placement.
The StorageLibrary is designed to operate in a horizontal position. Do not attempt to operate the
StorageLibrary in any other position than horizontally. Also make sure that:
The airflow around the front and back of the StorageLibrary is not obstructed.
There is a minimum of 60cm free space in front of the unit to allow the operator to safely remove
the magazines.
The display and operator controls can easily be accessed.
The StorageLibrary is away from the floor and in a clean environment with temperatures within
specifications. For specifications and safety information, see
Specifications and Safety and
Regulatory Information.
The Rack mounting Kit includes the following items:
Rack mount Ears (2 ears and 8 screws M3x4)
Left Rail Assembly
Right Rail Assembly
Screw M6x12 (6 pieces)