Tandberg Data T40 User Manual
Page 21
StorageLibrary Installation and User Guide
13
Recommended mounting tools:
Folding rule or tape measure
Screwdriver
7 mm open-end wrench
Figure 5. Rack mounting Kit with Rack mount Ears (Right figure)
Mounting the Rack mount Ears
To mount the rack mount ears, the four magazines must be removed. To remove the magazines,
follow the instructions below:
1 Connect the power cord to the power connector on rear of the library.
2 Turn on the power switch on the rear of the library.
3 Wait until the library completes its power-on sequence.
4 Use the front panel interface to remove the magazines (Menu > Operations > Eject Magazine).
5 Physically remove the magazines from the library, see
Magazine Handling
.
6 If your library supports 24 magazine slots only, you need to use the emergency eject tool to
remove the two upper magazines. The emergency eject tool is located at the rear of the library.
See
Manual/Emergency Release of Magazines
7 Mount the ears to the chassis of the library, see
Figure 6. Mounting the Rack mount Ears
.
8 Gently reinsert the magazines into the library.
Figure 6. Mounting the Rack mount Ears