Toshiba E-STUDIO230/280 - Manual (Page 42)

40
1.BEFORE USING EQUIPMENT
4.SETTING COPY PAPER (Cont.)
1
4 While pushing the size selection lever in
the direction of the arrow, set the side
guide to the desired paper size (indicated
on the bottom inner surface of the
drawer).
- Adjust the side guides with both hands.
5 Push the arrow part (left side) to lock the
size selection lever.
6 Place paper in the drawer(s).
- Place paper face up.
- Maximum number of sheets that can be set. "Acceptable Copy
Paper Types and Sizes" Page 36
- Fan the paper well before placing it in the drawer.
- Do not add paper above the line indicated on the guide.
- Do not use creased, folded, wrinkled or damp sheets of paper.
Make sure that a gap of approx. 0.5 mm (less than 1 mm in total) is
left between the paper and the side guide. If there is no gap, this
could cause paper misfeeding.
7 Push the drawer straight into the copier
until it comes to a stop.
- Be sure to push the drawer fully in.
Be careful not to let your fingers be caught when closing the drawer.
This could injure you.
0.5mm
(0.02'')