Telex Integrated Signal Processor ISP-100 - Manual (Page 80)

8-10
10 July 1998
Using the UP/DOWN Arrows
To increase the level, click on the up arrow. To decrease the
level attenuation, click on the down arrow. The amount of
increase or decrease is controlled by the fine/coarse control.
Fine (F) or Coarse (C) Control
This button determines the increment/decrement associated with the
UP/DOWN arrows. Fine produces small steps in value, while Coarse
provides large steps in value. Clicking on the button will toggle the
setting.
Knee Control
This button determines the type of transition that occurs when the
component goes from inactive to active. A Hard knee causes the
response by the component to be abrupt, while a Soft knee causes a
gentle response. Clicking on the button will toggle the setting.
Ratio Control
To change settings, click on the arrow next to the number in the text
box. A selection list will appear. The list may or may not be
scrollable. To make a selection click on the desired entry.
Sidechain
To make a selection click on the desired entry.
Bypass Control (master)
This button determines if the component is in the processing chain. If
the LED on the button is gray, then the component is inserted into
the signal processing chain. If the LED is red, then the component is
bypassed in the signal processing chain. A bypassed component will
be colored red in the QuickMAP.