Telex Integrated Signal Processor ISP-100 - Manual (Page 122)

8-52
10 July 1998
Select
Figure 8-20 Select component.
The select function (see Figure 8-20) allows you to set the source that
feeds portions of a QuickMAP. The user is allowed to select from as
many inputs as the QuickMAP allows. An entire QuickMAP can be fed
from a single source or multiple sources depending on the settings of the
Selects within the QuickMAP.
Note: The amount of available sources is determined by the QuickMAP
and not the hardware configuration. For example: A particular QuickMAP
has three source selects in it. This will require two input cards. The user
is only able to select from three inputs (as determined by the QuickMAP)
even though two input cards provide a total of four inputs in terms of
hardware.
Selecting the Input
To select the input click on the button next to the input that you want
to make active. The LED on the button should turn from gray to
green. If a particular button is grayed out then it is not available for
selection.