Telex Integrated Signal Processor ISP-100 - Manual (Page 67)

7-15
Using VUE-IT
Output
The Output function controls the output levels from the unit.
Using the Stereo Control
This button controls the tracking of the Gain/Attenuator levels. If
the LED is gray, then the two channels do not track each other. If
the LED is blue, then the channels will track each other. Clicking
on the button will toggle the setting.
Mute Control
This button determines if the output signal will be muted. A gray
LED indicates that the signal is not muted, while a red LED
indicates that the signal is muted. Clicking on the button will
toggle the setting.
Using the Relay Control
This button activates and deactivates the output relays. A gray
LED indicates that the audio path is not complete. A green LED
indicates that the audio path is complete. Clicking on the button
will toggle the setting.
Gain
To change settings, click on the arrow next to the number in the
text box. A selection list will appear. The list may or may not be
scrollable. Click on the desired entry to make a selection.
Digital I/O
In Mute (RX)
Mutes the AES receiver data stream.
Out Mute (TX)
Mutes the AES transmitter data stream
Pass Through
Routes the input from the receiver directly through the transmitter
to the card’s output (the output data from the DSP is bypassed).
Either the In-Mute or Out-Mute will mute the output when Pass
Through is on. Data may still be received when Pass Through is
on. Pass Through is only valid with a 48 kHz bit stream, or with a
non-48 kHz bit stream and Sample Rate conversion enabled. A
non-48 kHz sample rate with no sample rate conversion will result
in an error when the Pass Through option is selected.
SRC
Clicking on the SRC button turns on the Sample-Rate-Converter.
The SRC is used to convert non-48 kHz data streams into 48 kHz
data streams compatible with the ISP-100.
Note: Turning on the SRC will result in a 20-bit output data stream
except in the case of Pass Through.