Telex Integrated Signal Processor ISP-100 User Manual
Page 44
5-2
10 July 1998
Figure 5-2 OS download request dialog.
Figure 5-1 OS mismatch dialog.
Updating the ISP-100’s Operating System
The updating of the operating system contained in the ISP-100’s flash
memory is usually required after loading a new version of VUE-IT on the
computer. A dialog box such as those in Figures 5-1 and 5-2 usually
indicates this.
The procedure is as follows:
1. Make sure both the computer and the ISP-100 are both turned off.
2. Connect the computer to the ISP-100.
3. Hold in the default switch located to the left of the power switch and turn
on the ISP-100. Continue to hold in the default switch until the LEDs turn
red and begin rotating. See Figure 2-1 item 6.
4. Turn on the computer and start the VUE-IT software. You should see a
dialog box similar to that in Figure 5-2.