Quantum ATL M-Series - Manual (Page 91)

Chapter 3 Changing the Library Configuration
Changing the Ignore Host Lock Setting
ATL M-Series User’s Guide 73
Changing the Ignore Host Lock Setting
3
The Ignore Host Lock option controls whether the library can
release the mailbox when the host has issued a SCSI command to
lock the media:
• Enabling this option allows you to release the mailbox even
when the host has issued a SCSI command to lock the media.
• Disabling this option causes the library to display an error
message when you try to release the mailbox when the host has
locked the media.
To change the Ignore Host Lock setting:
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Ignore Host Lock is
highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Ignore Host
Lock setting. The available settings are Enabled or Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is
Disabled
.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.