Quantum ATL M-Series - Manual (Page 78)

Chapter 3 Changing the Library Configuration
Changing the Sync Negotiation Setting
60 ATL M-Series User’s Guide
Changing the Sync Negotiation Setting
3
The Sync Negotiation option controls whether the library robotics
negotiates synchronous data transfer mode. Normally, this
negotiation is performed by the host.
To enable or disable Sync Negotiation :
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Sync Negotiation is
highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Sync
Negotiation setting. The available settings are Enabled and
Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: This option does not enable or disable synchronous data
transfers; it only controls the ability of the library to
negotiate for such transfers.
Note: The default setting is Enabled .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.