Quantum ATL M-Series - Manual (Page 83)

Chapter 3 Changing the Library Configuration
Changing the Off-Line Time Setting
ATL M-Series User’s Guide 65
Changing the Off-Line Time Setting
3
When you access the Menu screen using the GUI, the library
becomes NOT READY and will not respond to any SCSI
commands issued. If you leave the library unattended in menu
mode, the library goes back to a READY state after a pre-set
time-out, controlled by the Off-Line Time option. You can set this
time-out to any value from 1 to 99 minutes, or turn it off.
To set the
Off-Line Time :
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Off-Line Time is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Off-Line Time
setting. The available settings are 1 through 99 and Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is
Disabled
.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.