Quantum ATL M-Series - Manual (Page 117)

Chapter 6 Running the Demonstration Programs
Running the Demo 1 Program
ATL M-Series User’s Guide 99
Running the Demo 1 Program
6
The Demo 1 program causes the robot to pick a randomly selected
cartridge from its magazine slot and place it in another randomly
selected magazine slot.
To run the
Demo 1 program:
1 Verify that at least one magazine is installed in the library and
that at least one cartridge is present.
2 Access the Demo Programs screen (see Accessing the Demo
Programs Screen ).
3 Press the Up or Down buttons to select Demo 1 .
4 Press Select .
The Demo 1 program starts. This program continues until you
press the Stop button.
5 If desired, include the drives or the fixed slot in the test:
a If the library is an ATL M1500 in a multiple library stack or
an ATL M2500, press the Level button to select the level
where the desired drive or fixed slot is located.
b Press Drive 1 or Drive 2 to include a drive.
c Press Fixed to include the fixed slot.
6 To stop the program, press Stop .
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
7 Press Back to return to the Demo Programs screen.