Quantum ATL M-Series - Manual (Page 121)

Chapter 6 Running the Demonstration Programs
Running the Demo 5 Program
ATL M-Series User’s Guide 103
Running the Demo 5 Program
6
The Demo 5 program causes the robot to pick a randomly selected
cartridge from its magazine slot and place it in another magazine
slot on another level of the stacked library. This test maximizes the
use of the StackLink.
To run the Demo 5 program:
1 Verify that at least:
• Two library modules are installed in the stack
• One magazine is installed in each library module
• One cartridge is present
2 Access the Demo Programs screen (see Accessing the Demo
Programs Screen on page 97).
3 Press the Up or Down buttons to select Demo 5 .
4 Press Select .
The Demo 5 program starts. This program continues until you
press the Stop button.
5 To stop the program, press Stop .
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
6 Press Back to return to the Demo Programs screen.
Note: This program is for multiple library stacks only.