Quantum ATL M-Series - Manual (Page 122)

Chapter 6 Running the Demonstration Programs
Running the Demo 6 Program
104 ATL M-Series User’s Guide
Running the Demo 6 Program
6
The Demo 6 program causes the X, Y, and Theta axes to move
randomly.
To run the
Demo 6 program:
1 Access the Demo Programs screen (see Accessing the Demo
Programs Screen on page 97).
2 Press the Up or Down buttons to select Demo 6 .
3 Press Select .
The Demo 6 program starts.
4 To stop the program, press Stop .
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
5 Press Back to return to the Demo Programs screen.