Quantum ATL M-Series - Manual (Page 84)

Chapter 3 Changing the Library Configuration
Changing the Barcode Scanner Setting
66 ATL M-Series User’s Guide
Changing the Barcode Scanner Setting
3
The Barcode Scanner option controls whether the bar code scanner
is enabled or disabled. When the scanner is enabled, the library
attempts to detect a bar code on all tape cartridge labels. If the
correct bar code labels are not used, or if some cartridges are not
labeled, scanning time may be greatly increased. Therefore, it is
recommended that you disable the Barcode Scanner option if you
do not intend to use compatible bar code labels.
To enable or disable the
Barcode Scanner option:
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Barcode Scanner is
highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Barcode
Scanner setting. The available settings are Enabled and
Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is Enabled .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.