Quantum ATL M-Series - Manual (Page 90)

Chapter 3 Changing the Library Configuration
Changing the Auto-Clean Setting
72 ATL M-Series User’s Guide
Changing the Auto-Clean Setting
3
To enable or disable Auto-Clean :
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Auto-Clean is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Auto-Clean
setting. The available settings are Enabled or Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is Disabled .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.