Ricoh 500SE - Manual (Page 83)

80
V
a
rio
u
s
S
hoo
ting
Fu
nc
tion
s
1
Note ----------------------------------------------------------------------------------------------
• The white balance may not be adjusted correctly for a subject that is mostly dark. In
this case, add something white to the subject.
• When shooting with the flash, the white balance may not be adjusted correctly if
[AUTO] is not selected. In this case, switch to [AUTO] to shoot with flash.
1
Turn the mode dial to 5/K/3.
2
Press the ADJ. button.
3
Press the #$ buttons until the white balance menu
appears.
4
Press the !" buttons to select
[M].
5
Point the camera at a piece of
paper or something white
under the lighting conditions
for your picture.
6
Press the DISP. button.
• The white balance is set.
7
Press the MENU/OK button.
• The symbol appears on the screen.
• The screen is displayed with the white
balance set in Step 6. If the result is
not as expected, repeat Steps 5 and 6
to change the settings as many times
as required.
Note ----------------------------------------------------------------------------------------------
To cancel [MANUAL SETTINGS], select a setting other than [M] in Step 4.
Setting the White Balance Manually
(MANUAL SETTINGS)