Ricoh 500SE - Manual (Page 165)

162
8
Usin
g
th
e
Blu
e
to
o
th
®
Fu
nc
tio
n
The authentication passkey is a code used to authenticate two
devices connecting using the Bluetooth
®
function.
If the passkey is set on the destination
device, a message appears when
connecting to that device. Follow the
procedure below to enter the passkey.
1
Press the MENU/OK button.
• The keyboard screen appears.
2
Use the keyboard to enter the
passkey set on the destination
device.
• For information on how to use the
keyboard, see P.163.
• To set the passkey on the destination
device, see the documentation that came with the destination device.
• You have 30 seconds to enter the passkey. If you do not enter the
passkey within the allotted time, an error message appears. Press the
MENU/OK button and start again from steps before entering the
passkey.
• If you enter the incorrect passkey, an error message appears. Press
the MENU/OK button and start again from steps before entering the
passkey.
3
Press the MENU/OK button.
• The destination device is connected and the transfer of images begins.
Note ----------------------------------------------------------------------------------------------
• You do not need to enter a passkey to connect to authenticated devices for which you
have entered a passkey in the past.
• The maximum size of the passkey that can be entered with this camera is 16
alphanumeric characters.
• You can set the authentication passkey for a destination device on the camera
beforehand so the camera can automatically authenticate the device without the need
to enter the passkey. (GP.175)
• If the passkey input screen appears on the destination device before appearing on the
camera, enter the passkey on the destination device, and then enter the same
passkey on the camera.
Entering an Authentication Passkey for a
Destination Device