Ricoh 500SE User Manual
Page 115
112
Ch
an
g
in
g
Camera S
e
ttin
g
s
6
You can use the ADJ. button to display the screens for setting the
exposure compensation and white balance with fewer button
operations and without displaying the Shooting Setting menu.
You can also use [ADJ BTN. SET.1] and [ADJ BTN. SET.2] to add
a camera function that can be activated by pressing the ADJ.
button.
To assign a function to either [ADJ BTN. SET.1] or [ADJ BTN.
SET.2], follow the steps below.
1
Display the SETUP menu.
• For the operating procedure, see P.107.
2
Press the " button to select [ADJ BTN. SET.1] or [ADJ
BTN. SET.2], and then press the $ button.
3
Press the !" buttons to select
the desired setting.
4
Press the MENU/OK button, or
# button and press the MENU/
OK button.
Note ----------------------------------------------------------------------------------------------
For information on how to use the ADJ. button, see P.56.
Assigning a Function to the ADJ.
Button (ADJ BTN. SET.)
Available Settings
Refer to
OFF *Default setting for [ADJ BTN. SET.2]
-
ISO (ISO SETTING)
P.81
QUALITY (PIC QUALITY/SIZE)
P.61
FOCUS
P.64
SHARP (SHARPNESS)
P.68
METERING (PHOTOMETRY)
P.67
CONT MDE (CONT. MODE)
P.69
ANTIBLUR *Default setting for [ADJ BTN. SET.1]
P.63