Ricoh 500SE - Manual (Page 102)

99
Di
rect
Pri
n
ti
n
g
5
Connect your camera to a printer using the USB cable provided.
1
Make sure that the camera is off.
2
Turn the terminal cover knob
of the camera in the direction
of the arrow to open the cover.
3
Connect your camera to a
printer using the USB cable
provided.
• Turn on the printer if it is not already
on.
Caution------------------------------------------------------------------------------------------
Before opening or closing the battery/card cover or terminal cover, be sure to remove any
water, sand or mud adhering to the camera, and avoid opening and closing the cover in
places where such contaminants may get inside the camera.
Note ----------------------------------------------------------------------------------------------
To disconnect the camera from the printer, check that the power is off on both units
before disconnecting the USB cable between them.
Connecting the Camera to a Printer