Ricoh 500SE - Manual (Page 125)

122
Ch
an
g
in
g
Camera S
e
ttin
g
s
6
If the initial settings are changed for the following functions, you can
set the camera to have the icon of that function blink and to display
a warning message about the function with the changed setting for
a few seconds when the camera is turned on.
White balance, Focus, ISO setting, Exposure compensation,
Time exposure
If you operate a camera button while an icon is blinking, the icon
stops blinking and lights steadily. If you operate a camera button
while the warning message is displayed, the message disappears.
To set change warning, follow the steps below.
1
Display the SETUP menu.
• For the operating procedure, see P.107.
2
Press the " button to select [SHTG STGS WARNG.]
and press the $ button.
3
Press the !" buttons to select
the desired setting.
4
Press the MENU/OK button, or
# button and press the MENU/
OK button.
Displaying a Settings Change
Warning (SHTG STGS WARNG.)
Available Settings
ON (Enable warnings) *Default setting
OFF (Disable warnings)