Roland LX-10 - Manual (Page 92)

92
Connecting to Other Devices
You can connect audio devices to play the sound of the LX-10
through the speakers of your audio system, or to record your
performance on a tape recorder or other recording device.
Use phone plug audio cables (sold separately) to make
connections.
Before connecting audio cables to the bottom panel
(the back edge of the LX-10’s bottom), you’ll need to
remove the rear board upper (p. 18).
1. Turn the volume all the way down on the LX-
10 and on the device you’re about to
connect.
2. Turn off the power to the LX-10 and
connected speakers.
3. Use audio cables (sold separately) to make
the connection.
4. Switch on the LX-10.
5. Switch on the connected speakers.
6. Adjust the volume level on the LX-10 and the
connected speakers.
When you play the LX-10’s keyboard, the sound is played
from the connected speakers.
Turning Off the Power
1. Turn the volume all the way down on the LX-
10 and on the connected speakers.
2. Turn off the connected speakers.
3. Turn off the LX-10.
Connecting to Audio Equipment
NOTE
926a
* When connection cables with resistors are used, the
volume level of equipment connected to the input jacks
may be low. If this happens, use connection cables that
do not contain resistors.
* To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
Connecting Speakers to the LX-10 and Outputting Sounds
Output Jacks
Amplified Speakers,
Audio System, etc.
Input (Line In)
LX-10_e.book 92 ページ ２００８年９月２２日 月曜日 午前１０時５１分