Roland LX-10 - Manual (Page 85)

85
Various Settings
When you press the pedal during Dual play or Split play, the
pedal effect is normally applied to both tones, but you can also
select the tone to which the effect is to be applied. This setting
can be changed for each pedal.
When you turn on the power, the left pedal functions as the soft
pedal, and the center pedal functions as the sostenuto pedal (p.
22). You can change the function of the pedal to a variety of other
operations.
Here you can make various MIDI-related settings for the LX-10.
For more about MIDI, refer to “Connecting to MIDI Devices” (p.
94).
When you have a MIDI sequencer connected, set this parameter
to Local Off.
Since the Thru function of your sequencer will normally be
turned on, notes played on the keyboard or played back by the
recorder will be transmitted to the sound generator by the two
routes (1) and (2) shown in the illustration, causing notes to be
sounded in duplicate or to be cut off unnaturally. To prevent this,
the setting called “Local Off” is used to disconnect the route in
(1).
fig.LocalCntr.e
Local On: The keyboard and recorder are connected to the
internal sound generator.
fig.LocalOn.e
Local Off: The keyboard and recorder are not connected to the
internal sound generator. No sound will be produced
by the keyboard when it is played.
fig.LocalOff.e
Pedal Settings
Changing How the Pedal Effects Are
Applied (Damper/Center/Left Pedal Part)
Setting Description
Right & Left All enabled
Right
Applied only to the Tone 1 (in dual mode)/
Right-hand Tone (in split mode)
Left
Applied only to the Tone 2 (in dual mode)/
Right-hand Tone (in split mode)
Changing How the Pedals Work
(Center/Left Pedal Func)
Function Description
Damper Sets function to damper pedal.
Soft Sets function to soft pedal.
Sostenuto Sets function to sostenuto pedal.
Expression Allows control of the volume.
Play/Stop
The pedal will have the same function as the
[
] button.
Effect Sw
Effects can be switched on/off by pressing
the pedal instead of pressing the [Effects]
button. When effect type is rotary, you can
control the slow/fast of spinning.
Bend Up Pitch rises by pressing the pedal.
Bend Down Pitch lowers by pressing the pedal.
Modulation Vibrato is added by pressing the pedal.
Layer
Pressing the pedal will layer on Tone 2, used
for Dual play.
* The Layer function can be applied only when
using Dual play (p. 42).
Octave
Pressing the pedal will layer on a sound one
octave higher.
* The Octave function cannot be applied while
using Twin Piano (p. 40), Dual play (p. 42), or
Split play (p. 45).
MIDI Settings
Preventing Doubled Notes When
Connected to a Sequencer (Local Control)
(1)
MIDI
MIDI MIDI
MIDI
(2)
IN
IN OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played is sounded twice
Soft Thru On
Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
LX-10_e.book 85 ページ ２００８年９月２２日 月曜日 午前１０時５１分