Roland LX-10 - Manual (Page 23)

23
Before You Play
You can use headphones to enjoy the LX-10 without disturbing
those around you, such as at night. Since the LX-10 has two
headphone jacks, two people can also use headphones
simultaneously.
If you’re using only one set of headphones, you may connect
them to either of the two headphone jacks.
fig.Headphones.eps
1. Plug the headphones into the Phones jack
located at the left of front side bottom of the
LX-10’s bottom panel.
If headphones are connected, no sound will be output
from the LX-10’s speakers.
2. Use the LX-10’s [Volume] knob (p. 21) to
adjust the headphone volume.
Cautions when Using Headphones
• To prevent damage to the cord’s internal conductors, avoid
rough handling. When using headphones, mainly try to
handle either the plug or the headset.
• Your headphones may be damaged if the volume of a device
is already turned up when you plug them in. Minimize the
volume before you plug in the headphones.
• Excessive input will not only damage your hearing, but may
also strain the headphones. Please enjoy music at an
appropriate volume.
• Use headphones that have a stereo 1/4” phone plug.
Whenever you are not using the headphones, you can hang
them on the headphone hook of the LX-10.
Attaching the Headphone Hook
1. Press and twist the headphone hook
included with the LX-10 into the hole in the
bottom left of the LX-10 (refer to the figure
above).
2. Turn the headphone hook wing nut to secure
the headphone hook.
Do not hang anything other than headphones on the
headphone hook. Doing so may damage the
instrument or the hook.
If headphones are connected, a headphone symbol is
shown in the lower left of the screen.
fig.PhonesMark.eps
Listening through
Headphones
Headphones
Using the Headphone Hook
Headphone Hook
Wing Nut
NOTE
LX-10_e.book 23 ページ ２００８年９月２２日 月曜日 午前１０時５１分