Roland LX-10 - Manual (Page 41)

41
Performing
1.
Press the [Twin Piano] button, getting its indicator to light.
fig.d-TwinPiano.eps
When you turn Twin Piano on, the instrument will be in the following state.
• The keyboard will be divided into left and right areas, with “middle C” located in the center of
each area.
• The left and right areas will have the same sound (Grand Piano 1).
• The right pedal will be the damper pedal for the right area, and the left pedal will be the damper
pedal for the left area.
• If the Split function or the Dual function was on when you turned Twin Piano on, the Split function
and the Dual function will be turned off.
• 3D Sound Control and the effect will be off.
Turning Off Twin Piano
1. Press the [Twin Piano] button so its illumination is turned off.
1. Hold down the [Twin Piano] button and press the [-] [+] buttons.
You can choose one of the following ways in which the sound will be heard.
fig.d-TwinPianoMode.eps
If you set Twin Piano mode to “2,” reverb will no longer be applied when you turn on Twin Piano
mode.
For some sounds, the sound may not be split even if you set Twin Piano mode to “2.”
You can use the Memory Backup function to store this setting in internal memory (p. 89).
Changing the Way in which the Sound is Heard (Twin Piano Mode)
Indicate Description
1
As usual, the sound will be heard from the right as you play toward the right of the keyboard,
and from the left as you play toward the left.
2
Notes played in the right area will be heard from the right speaker, and notes played in the
left area will be heard from the left speaker.
NOTE
NOTE
LX-10_e.book 41 ページ ２００８年９月２２日 月曜日 午前１０時５１分