Ricoh AP2610N - Manual (Page 62)

Configuring the Printer for the Network
48
3
IEEE 802.11b (Wireless LAN) Configuration
Configure the printer for using the
wireless LAN. The following table
shows the control panel settings and
their default values. These items are
included in the "Host Interface"
menu.
In order to use the wireless LAN, se-
lect "IEEE 802.11b" for "LAN Type" in
"Network Setup" of the Host Interface
menu, and then set "IP Address",
"Subnet Mask", "Gateway Address",
"Network Boot", "Frame Type (NW)"
and "Active Protocol" in the "Net-
work Setup". For more information
about setting the items in the "Net-
work Setup", see p.41 “Ethernet Con-
figuration”.
AAAA
Press
{{{{Menu}}}}.
“Menu” appears on the panel dis-
play.
BBBB
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to display “Host
Interface” menu.
CCCC
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
DDDD
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to display "IEEE
802.11b".
EEEE
Press
{{{{Enter #}}}}.
Be sure that "Comm. Mode" ap-
pears on the panel display.
Setting Name Value
Comm. Mode Ad hoc
Channel • Inch version
(1-11) 11
• Metric version
(1-13) 11
Trans. Speed Auto
WEP Settings Not Active
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In
ZFDP020N
Menu:
Host Interface
Host Interface:
I/O Buffer
Host Interface:
IEEE 802.11b
IEEE 802.11b:
Comm. Mode
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In
ZFDP060N