Ricoh AP2610N - Manual (Page 44)

Installing Options
30
2
GGGG
Place the controller board on a flat
surface.
HHHH
Use a coin to remove the two
screws, and then remove the cov-
er.
Note
❒ These screws are used again in
step J .
IIII
Attach the 802.11b Interface Unit.
Insert the end of the 802.11b Inter-
face Unit into the opening (
A), and
then push down until it clicks (
B).
JJJJ
Fasten the 802.11b Interface Unit
to the controller board with the
two screws.
KKKK
Insert the card slowly into the
802.11b board with the label fac-
ing down and the uneven black
antenna surface facing up until it
stops.
LLLL
Match the controller board to the
top and bottom rail using the "
T T T T"
mark, and then slide it into the
printer slowly until it stops.
ZGDX410J
ZGDX420J
ZGDX431J
ZGDX442J
ZGDX500J
ZGDX251J