Ricoh AP2610N - Manual (Page 325)

Setting Up a Client Computer
35
3
Setting Up a Client Computer
This section describes the procedures for setting up a client in a network that
uses Windows 2000, Windows XP, Windows NT Server or Windows NT Work-
station as a print server.
When using a Windows 2000, Windows XP or Windows NT print server, select
a shared printer on Windows 2000, Windows XP or Windows NT.
Limitation
❒ When using a print server connected to the printer with SmartNetMonitor for
Client, you cannot use Recovery Printing and Parallel Printing.
Note
❒ This section assumes that the client has already been configured to communi-
cate with a Windows 2000, Windows XP or Windows NT print server. Do not
begin the following procedure until the client has been set up and configured
correctly.
Use the [Printers] window to set up the printer.
AAAA
Access the [Printers and Faxes] window from [Start] on the taskbar.
BBBB
Click [Add Printer] in the Printer Tasks category.
This launches the Add Printer Wizard.
CCCC
Click [Next >].
DDDD
Click [[A network printer, or a printer attached to another computer.], and then click
[Next >]
.
EEEE
Click [Next >].
Windows XP
Windows 2000, Windows XP or
Windows NT Print Server