Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 52)

36
Note Setting the mode pins using the E8Direct requires caution. Please confirm the pin settings with
the hardware manual even if a default setting is available. Note that in some devices, changing the
mode pin setting changes the maximum supply voltage.
If the E8 has not yet been restarted as an E8Direct device then the following messages will appear in
the FDT output window:
Preparing for re-enumeration of E8 to E8Direct...
Sending re-enumeration command...
Request sent successfully, closing E8 Comms...
At the same time Windows
®
will re-enumerate the device (see also Chapter 13 - E8Direct).
When the ‘Select USB Device’ Dialog is displayed you must select which E8Direct unit is to be
used to set up the connection.
Figure 3-19 Select USB Device
3.5.6 Generic Boot - Confirmation
FDT then waits for you to confirm that the device is connected and powered, and if not using the FDM
or E8Direct, in Boot mode. FDT will try to connect to the device when you click ‘OK’.
Figure 3-20 Generic Boot Confirmation
After this, FDT displays a dialog that displays the boot progress. At various points during the Generic
Boot process, the user is required to select or confirm details of the device; see below for details.