Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 36)

20
3.3 Starting FDT
3.3.1 Starting FDT without Security or Simple Interface Mode enabled
To start FDT, open the ‘Start’ menu of Windows
®
and select ‘Programs’ -> ‘Renesas’ -> ‘Flash
Development Toolkit 3.05’, then the ‘Flash Development Toolkit 3.05’ shortcut. The ‘Welcome’ dialog
box will open by default.
Figure 3-1 Welcome Dialog
To create a new workspace, select ‘Create a new Project Workspace’ and click the ‘OK’ button (see
section 3.4.1 for details). To open a recent workspace, select ‘Open a recent project workspace’ and the
workspace to be opened from the list box. To open an existing workspace which is not in the list of
recently used workspaces, select ‘Browse to another project Workspace’. Finally, click the ‘OK’ button.
3.3.2 Starting FDT in Basic Simple Interface Mode
To start FDT in Basic Simple Interface Mode, open the ‘Start’ menu of Windows
®
and select
‘Programs’ -> ‘Renesas’ -> ‘FLASH Development Toolkit 3.05’, then the ‘Flash Development
Toolkit 3.05 Basic’ shortcut. The previous FDT Basic settings will be restored, and new settings can be
entered by selecting the Options->New Settings… menu item.
3.3.3 Starting FDT by double clicking on a workspace file
FDT can be started by double clicking on a workspace file from Windows
®
Explorer. This will cause
FDT to load the selected workspace upon start up.
3.3.4 Starting FDT by double clicking on a data file
FDT can be started by double clicking on a registered data file from Windows
®
Explorer (if this default
option was not unselected during installation). This will cause FDT to load the selected data file upon
start up.