Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 131)

115
11.1.4 Request Checksum
This option controls whether FDT automatically performs a checksum request operation after
programming. The setting is remembered between sessions.
11.1.5 Erase Device Before Program
This option controls whether FDT automatically performs an erase operation before programming the
device. This will erase all blocks in all memory areas prior to programming. The setting is remembered
between sessions.
11.1.6 Security Protection
This option controls whether FDT should security protect QzROM devices as it disconnects. Select
“Automatic” to always protect the device at disconnection. Select “Prompt” to query the user what to
do and select “None” to never protect the device at disconnect. NB – a protected device cannot be
reconnected to.
11.1.7 Field Programming->Run Published File…
Unpackage another .fpf file and use it in Simple Interface Mode.
11.1.8 About…
Shows the About box.
11.2 Dialog Controls
11.2.1 Back to Project
This returns to the full FDT Workspace view. This will be disabled if the user currently logged in to
FDT does not have the ‘FDT:Project Edit’ access. [see Chapter 5 for details]
11.2.2 Exit
Clicking this will exit FDT and FDT will start up in the Simple Interface Mode next time it is loaded.
This will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Exit’
access. [see Chapter 5 for details]
11.2.3 Download Project image radio button
This will be disabled if the user currently logged in to FDT does not have the
SimpleInterface:Download Project Image’ access. [see Chapter 5 for details]
11.2.4 Program Flash
Clicking on Program Flash allows FDT to download the specified file or image to the FLASH
memory. Additionally, if Readback Verify is switched off, the Checksum will also be calculated and
output to the screen.