Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 43)

27
Note To enter the clock mode, input clock, and multipliers, refer to the device hardware manual
and/or the target board manual to confirm the values required.
3.4.5 Connection Type
Select whether the connection is for Boot Mode or User Mode in the ‘Connection Type’ dialog.
Additionally, for a connection to a kernel that is still running on the device from a previous session,
select the ‘Kernel already running’ check box. Next, select the communication speed (bps) if the default
value is not correct or not present. Speeds where the target error rate is greater than 4%, or the
FDM\E8Direct error rate is greater than 0% are automatically removed from the recommended list.
When using the FDM\E8Direct the ‘User Specified’ connection speed option is enabled; when selected,
this allows the user to specify a non-standard baud rate. The error rate will be displayed – this takes into
account the target peripheral clock rate, the target Bit Rate Register calculation formula, and the
FDM\E8Direct characteristics.
Click the ‘Next’ button to continue.
Figure 3-6 Connection Type
Note that ‘Use Default’ is designed for use with the Renesas Evaluation Board or Evaluation
Development Kits. Uncheck this to allow manual selection of the bit rate.