Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 101)

85
8.2.6 Properties...
Launches the device file properties dialog box.
8.2.7 Display Block usage...
Launches the ‘S-Record Properties’ dialog box and displays the Block usage tab.
8.2.8 Exclude ‘filename’
If a file is excluded, it will not be used to form the built image if Rebuild Image is selected.
Once selected as excluded, using the right mouse click, it is possible to “Include ‘filename’”.
8.2.9 User Boot Area
User Boot Area : When this option is selected (ticked), the selected file is tagged as being
destined for the User Boot Area. If not ticked, it will default to the User Area. This option is
only available if the target device supports a User Boot Area
8.2.10 Download File to [User Area] /[User Boot Area]
Downloads the selected file to the device FLASH memory. Note that the Flash Area used is
determined by whether the file is tagged as a User Boot Area file.
8.2.11 File Checksum
The file checksum returns the checksum for the file using the algorithm in the kernel (EPROM
style) and also a raw checksum. The raw checksum is a simple 32 bit addition of the byte
values within the range of the flash. The EPROM style checksum pads the data with 0xFF’s to
the next EPROM size (eg 64Kb, 128Kb etc) before calculating the checksum. The result is
shown in the output window. An example is shown below:-
File Checksum: 0x07F5A651 (EPROM style),
Raw Checksum: 0x07F5A651 (over address range 0x00000000 -
0x0007FFFF)
8.2.12 Compare File->Device Checksum
This command allows the user to compare the selected file checksum to the device checksum.
The output window will show the sum check for both the file and the device. The user may
then confirm that they are the same.
An example is shown below:-
Calculating device checksum
Flash Checksum: 0x07F5A651 (User Area)
File Checksum: 0x07F5A651 (EPROM style),
Raw Checksum: 0x07F5A651 (over address range 0x00000000 -
0x0007FFFF)