Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 39)

23
3.4 Creating a New Workspace and Project
When FDT is started in full mode (not FDT Basic Simple Interface Mode), a workspace and project must be
opened or created. See Chapter 10 Basic Simple Interface Mode for details on programming without setting
up a workspace and project.
3.4.1 New Project Workspace
Enter the workspace name (the project name is the same by default), then click the ‘OK’ button. If you
wish to change or create a directory, input a directory name or use ‘Browse...’ button.
Figure 3-2 New Workspace