Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 122)

106
9.1.2 AutoDisconnect
This forces FDT to automatically disconnect after programming, so that the user does not need to press
the Disconnect button.
9.1.3 Readback Verify
This option controls whether FDT automatically performs a read and compare operation after
programming. The default setting is taken from the project setting (“Readback Verification” on the
Programmer tab of the Project Properties window), but the user can override the default by selecting
this menu item.
9.1.4 Request Checksum
This option controls whether FDT automatically performs a checksum request operation after
programming. The setting is remembered between sessions.
9.1.5 Erase Device Before Program
This option controls whether FDT automatically performs an erase operation before programming the
device. This will erase all blocks in all memory areas prior to programming. The setting is remembered
between sessions.
9.1.6 Security Protection
This option controls whether FDT should security protect QzROM devices as it disconnects. Select
“Automatic” to always protect the device at disconnection. Select “Prompt” to query the user what to
do and select “None” to never protect the device at disconnect. NB – a protected device cannot be
reconnected to.
9.1.7 Field Programming->Run Published File…
Unpackage an .fpf file and use it in Simple Interface Mode.
9.1.8 About…
Shows the About box.
9.2 Dialog Controls
9.2.1 Back to Project
This returns to the full FDT view. This will be disabled if the user currently logged in to FDT does not
have the ‘FDT:Project Edit’ access. [see Chapter 5 for details]