Roland ATELIER AT-500 - Manual (Page 65)

63
Selecting and Playing Sounds
Selecting and Playing Sounds
1.
The volume levels of each part are adjusted using the
corresponding [
▲ ] and [ ▼ ] buttons.
Pressing the upper button ([ ▲ ] button) will increase the volume.
Pressing the lower button ([ ▼ ] button) will decrease the volume.
The volume can be set to any value from 0 to 12.
When the volume value shown in the display is 0, that part will produce no
sound.
You can also press the [ ▲ ] button or [ ▼ ] button of the part whose volume you
wish to adjust, so that the “Part Balance Monitor screen” is displayed for
several seconds, allowing you to check the volume balance.
fig.01-27.eps
The Part Balance Monitor
screen is displayed for several
seconds and then closes
automatically.
If you touch , the screen
continues to be displayed until
you touch .
AT-500_e.book 63 ページ ２００８年７月２８日 月曜日 午後４時１７分