Roland ATELIER AT-500 User Manual
Page 218
216
Various Other Settings
You can use your external display to view the contents of the
ATELIER’s built-in screen.
1.
Touch
The System screen appears.
2.
Touch <
> <
> to display the Screen Out.
fig.10-12.eps
3.
Touch the Screen Out setting to switch between
“ON” and “OFF.”
I If the Slide Show setting is on, the slide show will be shown
on your external display.
4.
Touch
You can also use the following procedure to turn the
V-LINK function on.
1.
Hold down the Composer [Reset] button
and press either the Upper Organ [Full]
button or the Upper Organ [Jazz] button.
Holding down the Composer [Reset] button and
pressing the Upper Organ [Full] button switches
the instrument to “MODE 1” (p. 215). Holding
down the Composer [Reset] button and pressing
the Upper Organ [Jazz] button switches the
instrument to “MODE 2” (p. 215).
The display changes as shown below, and the
ATELIER switches to Image Control mode.
fig.09-42.eps
The V-LINK function is turned on, and the V-LINK
icon appears in the main screen.
fig.09-41.eps
2.
To cancel the V-LINK function, once again
hold down the Composer [Reset] button
and press either the Upper Organ [Full]
button or the Upper Organ [Jazz] button.
If set to “MODE 1” (p. 215), holding down the
Composer [Reset] button and pressing the Upper
Organ [Full] button switches the V-LINK function
off. If set to “MODE 2” (p. 215), holding down the
Composer [Reset] button and pressing the Upper
Organ [Jazz] button switches the V-LINK function
off.
Viewing the Contents of the ATELIER’s
Screen on a External Display
Setting
Description
ON
The contents of the ATELIER’s screen will be
shown on your external display.
OFF
The contents of the ATELIER’s screen will not be
shown on your external display. The ATELIER
logo will be shown.
NOTE
AT-500_e.book 216 ページ ２００８年７月２８日 月曜日 午後４時１７分