Roland ATELIER AT-500 - Manual (Page 53)

51
Selecting and Playing Sounds
Selecting and Playing Sounds
Notice that there is an [Others] button for each part. By using the [Others]
button, you can select all voices.
As with the other voice buttons, the [Others] button can be assigned two
voices. You can use the [Alternate] button to switch between these two voices.
1.
Press the [Alternate] button for the Part for which you wish
to specify a voice to select ON (lit) or OFF (dark).
The setting of the [Alternate] button: ON (lit) or OFF (dark), determines to
which of the two available locations a newly selected voice will be assigned.
2.
Press the [Others] button for the Part for which you wish to
specify a voice.
The Others Voice screen appears for several seconds.
fig.01-15.eps
3.
Touch a button that shows a sound group.
fig.01-15.eps
Selecting a Voice Using the [Others] Button
A voice indicated by is
called an “EX voice.”
These voices are especially
recommended.
NOTE
When you press the [Others]
button, the Others Voice screen
appears in the display screen,
but the basic screen will
reappear if you wait several
seconds without touching the
screen.
If you want to change the voice
for the [Others] button, press
the [Others] button once more,
then select the voice by quickly
touching the screen while the
Others Voice screen appears in
the display.
Sounds marked by “ ”
support the Active Expression
function (p. 59).
AT-500_e.book 51 ページ ２００８年７月２８日 月曜日 午後４時１７分