Roland ATELIER AT-500 - Manual (Page 214)

212
Various Other Settings
You can specify the Program Change number that will be
transmitted from MIDI Out connector when a Registration is
selected.
1. Touch on the Main screen.
The System screen appears.
2. Touch < > < > to display the Bank MSB
(Bank Select MSB), Bank LSB (Bank Select LSB),
or PC Number (Program Change Number).
fig.00-37.eps
3. Touch either , , or Number> setting.
fig.09-28.eps
4. Touch < > < > to change the setting.
5. Touch .
This instrument contains two sound generators: one for GM2/
GS data playback and one for keyboard performance.
Normally, data received at the MIDI In connector will control
only the sound generator for GM2/GS data playback.
However by changing the MIDI IN Mode setting, you can also
control the keyboard sound generator from MIDI In.
1. Touch on the Main screen.
The System screen appears.
2. Touch < > < > to display the MIDI IN Mode.
fig.09-24.eps
3. Touch the MIDI IN Mode setting to switch
between “MODE 1” and “MODE 2.”
Each time you touch the MIDI IN Mode setting, it will
alternate between “Mode 1” and “Mode 2.”
Setting the PC Number
Menu Setting
Bank MSB 0–127
Bank LSB 0–127
PC Number 1–128
MIDI IN Mode
Setting Description
MODE 1 Control the instrument as a GS sound generator
MODE 2
Channels 5 through 10 and Channels 12, 14, 15
are transmitted to the GS sound generator, and all
other channels are transmitted to the keyboard
sound generator.
Channel MODE 1 MODE 2
1 GS Solo
2 GS Pedal/GS *
3 GS Lower
4 GS Upper
5–10 GS GS
11 GS Drums/SFX
12 GS GS
13 GS Manual Percussion
14–15 GS GS
16 GS Control
AT-500_e.book 212 ページ ２００８年７月２８日 月曜日 午後４時１７分