Roland ATELIER AT-500 - Manual (Page 220)

218
Various Other Settings
You can restore the User memory to their original factory
settings.
This function is called “User Memory Reset.”
1. Touch on the Main screen.
The System screen appears.
fig.00-37.eps
2. In the System screen, touch to open
the Utility screen.
fig.00-38.eps
3. In the Utility screen, touch .
fig.00-43-1.eps
The confirmation message appears on screen.
fig.00-43-2.eps
Touch to return to the System screen without
resetting the user memory.
4. Touch .
The user memory will be reset to the factory-set state.
Never switch off the power while this operation is in
progress!
fig.00-40-2.eps
To reset all settings other than User memory to their original
factory settings, refer to p. 219. If you want to reset all
settings to their factory-set state, refer to p. 24.
Restoring the User Memory to
the Original Factory Settings
What is User Memory?
“User Memory” refers to an area inside the instrument
where you can store the User Rhythms you create and the
performances you record. Rhythms and SMF music files
saved on USB memory can also be copied to user
memory (p. 87).
User memory is quite useful, since anything you place
there will be retained even while the power is turned off.
The following things are stored in User memory:
• Songs you’ve registered in “Favorites”
• Rhythms
• Registration sets
NOTE
AT-500_e.book 218 ページ ２００８年７月２８日 月曜日 午後４時１７分