Roland ATELIER AT-500 - Manual (Page 27)

25
Before You Start Playing
Before You Start Playing
The confirmation message appears on screen.
fig.00-40-1.eps
If you touch , the Factory Reset will not be
performed, and you will return to the System screen.
4. When you touch , the Factory Reset
operation will begin, and the settings will
return to the factory-set condition.
Never switch off the power while this operation is in
progress!
fig.00-40-2.eps
Loading factory default settings will erase any Registrations
currently in the memory of the ATELIER. To save the
Registrations you are currently using, refer to “Saving
Registration Sets” (p. 103).
If you want to restore settings other than those for User
Memory (p. 72) to the factory-set condition, touch Reset> in the System Utility screen. If you want to restore
only the user memory to the factory-set condition, refer to
page 218.
NOTE
NOTE
NOTE
You can also use the following method to return to the
factory-set condition.
Method 1
1. Touch on the Main screen,
to display the Quick Guide screen.
2. Press the [One Touch Program] button.
The confirmation message appears on screen.
fig.00-40-1.eps
If you touch , the Factory Reset will not be
performed, and you will return to the Main screen.
3. When you touch , the Factory Reset
operation will begin, and the settings will
return to the factory-set condition.
Method 2
1. Turn down the volume to the minimum
level, then turn off the power.
2. While holding down the [One Touch
Program] button, press the [Power On]
switch to turn the power on.
fig.00-41.eps
The following screen appears.
fig.00-40-3.eps
AT-500_e.book 25 ページ ２００８年７月２８日 月曜日 午後４時１７分