Ricoh RDC-i700 - Manual (Page 17)

15
1
Getting Started
Installation of the software for connecting the camera by USB cable will start.
Follow the instructions displayed on the screen. When installation is completed,
proceed to the next step.
Note
• Updated information on installation is provided in the [Readme] file in
the [Win98] and [Win2000] folders. If necessary, refer to this
information.
• When you connect/remove the USB cable or cancel installation before
installing the USB driver, the cable may be recognized as an unknown
device for a PC. Refer to page 169 “Troubleshooting” for
troubleshooting.
For Macintosh
If you are using a Macintosh, install the USB driver as follows.
A
Turn the PC on.
When the Macintosh is up and running, proceed to the next step.
B
Insert the CD-ROM provided in the CD-ROM drive of the PC.
C
Double-click on the CD-ROM. Next double-click on the [Usb driver]
folder, and then double-click on [RDC-i700 USB / Serial Inst].
Installation of the software for connecting the camera to the PC by USB cable
will start. Follow the instructions displayed on the screen. When installation is
finished, proceed to the next step.
Note
• Updated information on installation is given in the [Readme] file. If
necessary, refer to this information.