Ricoh RDC-i700 - Manual (Page 157)

155
7
Setting the Receiving PC for Direct Upload
■ Using the RDC-i700 Direct Communication software
A
Start up [RDC-i700 Direct Upload].
[RDC-i700 Direct Upload] is installed in the root folder of the startup disk
immediately after installation.
B
If you wish to make a direct upload log file (a record of
connections and transmissions), set a folder and file name.
The images transferred from the camera will be saved in the folder specified as
the destination folder.
If you do not need a log file, leave the log file name blank.
C
Click on [OK].
Direct upload is in standby status.
To use direct upload from outside the company, before leaving the company do
not forget to put the Macintosh in this status.