Raritan Computer DKX2-V2.3.5-0N-E - Manual (Page 250)

Chapter 12: Command Line Interface (CLI)
241
Name Command
The name command is used to configure the network name. The syntax
of the name is:
name [devicename ] [hostname ]
Device name configuration
devicename Device Name
hostname Preferred host name (DHCP
only)
Name Command Example
The following command sets the network name:
Admin > Config > Network > name devicename My-KSX2
IPv6 Command
Use the IPv6_command to set IPv6 network parameters and retrieve
existing IPv6 parameters.