Raritan Computer DKX2-V2.3.5-0N-E - Manual (Page 246)

Chapter 12: Command Line Interface (CLI)
237
Commands Description
help Display an overview of the CLI syntax.
quit Places the user back one level.
logout Logs out the user session.
Initial Configuration Using CLI
Note: These steps, which use the CLI, are optional since the same
configuration can be done via KVM. See
Getting Started (on page 14)
for more information.
KX II devices come from the factory with default factory settings. When
you first power up and connect to the device, you must set the following
basic parameters so the device can be accessed securely from the
network:
1. Reset the administrator password. All KX II devices are shipped with
the same default password. Therefore, to avoid security breaches it
is imperative that you change the admin password from raritan to
one customized for the administrators who will manage the KX II
device.
2. Assign the IP address, subnet mask, and gateway IP address to
allow remote access.
Note: Both IPv4 and IPv6 addresses are supported.
Setting Parameters
To set parameters, you must be logged on with administrative privileges.
At the top level, you will see the "Username" > prompt, which for the
initial configuration is "admin". Enter the top command to return to the
top menu level.
Note: If you have logged on with a different user name, that user name
will appear instead of admin.