Nortel Networks SRG 50 NN43001-307 - Manual (Page 74)

74 Dialing Plan configuration
FEAT ESN
CDP YES
MXSC 50
NCDP 4
DLTN YES
• Configure the CDP Distant Steering Code (DSC) in LD 87.
> LD 87
REQ NEW
CUST 0
FEAT CDP
TYPE DSC
DSC 50
FLEN 4
RLI 12
To configure the NRS (H.323 Gatekeeper/SIP Redirect Server):
• Create CDP Domain: MO_BO_CDP.
• Create H.323/SIP endpoints: MO, BO.
• Create Numbering Plan entries in CDP Domain:
— Add 40 for endpoint BO.
— Add 30 for endpoint MO.
— Add 42 for endpoint MO.
For information about configuring H.323/SIP Redirect Server, see IP Peer
Networking Installation and Commissioning (NN43001-313).
To configure the SRG:
• Configure DN and BUID as the same number on each of the redirected
IP Phones. For example, DN/BUID = 42XX.
• Set the main office VoIP Trunk Access code to 3. For example, main
office VoIP trunk access code = 3.
• Set the destination code for the VoIP trunk to 30 (retain all digits) or 34
(remove first digit). For example, BUID dialout = 342XX.
The VoIP route destination codes 30 (no digits dropped) and 34 (1 digit
dropped) route any call that starts with 30 or 34 out of the system over
the VoIP trunk to the main office.
The main office access code length is still 0.
• Assign the telephones registered to the SRG (IP Phones or analog
[500/2500-type]) telephones to a different range, such as 40XX. See the
NRS configuration above.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.