Nortel Networks SRG 50 NN43001-307 - Manual (Page 103)

Configuring Bandwidth Management parameters 103
Select the zone on the Zones web page (see Figure 30 "Zones web" (page
105) ) and click VGW and IP phone codec profile. Select an existing
codec or configure a new one in the VGW and IP phone codec profile
section, shown in
Figure 29 "Configuring a codec" (page 103) . See IP
Peer Networking Installation and Commissioning (NN43001-313) for full
instructions on configuring a codec.
Figure 29
Configuring a codec
Configuring Bandwidth Management
The steps to configure Bandwidth Management on the Call Server are as
follows:
Step Action
1 Define a VPNI number in LD 15.
2 Configure the Bandwidth Management parameters for each zone on
the Call Server using either Element Manager (see
"Configuration
using CS 1000 Element Manager" (page 104) ) or LD 117 (see
"Configuration using LD 117" (page 105) ).
• Call Server zones that will be used for endpoints (telephones
and gateways) with the following properties:
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.