Config, Config -13 – Nortel Networks 6300 User Manual
Page 71
3-13
Remote Annex 6300 Hardware Installation Guide
Chapter 3
ROM Monitor Commands
config
The config command displays the current configuration information
and revision levels for the Remote Annex 6300. The config command
displays revision information, the amount of memory installed, T1 or
E1 configuration information, and a description of the number and
type of modems installed. The command syntax is:
config
The config command display for a Remote Annex 6300 with 24
modems (T1) looks similar to this:
This display is typical for T1 versions. For E1 versions,
information on 32 ports will be shown. For modem-less
versions, no port or modem information will be shown.
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 1002
Board ID: 63
Board Type: RA6300
CPU Type: 486DX2
Ethernet Address: 00-80-2D-02-CE-A9
Memory size: 8 Meg
EEPROM size: 65504
Flash size: 2 Meg
Flash ID: 8989
Available Interfaces ( *= selected) ThickNet ThinNet *Twisted Pair
SLC Local DRAM Size: 4 Meg
SLC SRAM Size: 128 K
TDM Interface: PRI T1 USA
Revision: VERSION A MGR=1.117
Modem Country Code : 63
Port #
1
2
3
4
5
6
7
8
9
10
11
12
Modem ID
2883
2883
2883
2883
2883
2883 2883 2883 2883 2883 2883 2883
Mod Status
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
Port #
13
14
15
16
17
18
19
20
21
22
23
24
Modem ID
2883
2883
2883
2883
2883
2883 2883 2883 2883 2883 2883 2883
Mod Status
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK