Nortel Networks 6300 - Manual (Page 41)

2-5 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
Attaching the Mounting Bracket to the Remote Annex 6300
Attach the rear mounting bracket to the Remote Annex 6300 as
follows:
1 Remove the mounting brackets and hardware kit from its package.
2 Remove two screws from the rear of the cover on each side of the
Remote Annex 6300, as shown in
Figure 2-3 . Save these screws; you
will need them later to install the rear mounting bracket.
3 Install rear mounting brackets to the device using the four screws
previously removed and the additional hardware supplied in the
hardware kit.
4 Tighten the screws to secure the bracket to the device.
Figure 2-3. Attaching the Mounting Bracket to the Remote Annex 6300
Bracket Mounting
(2 Screws each side)
Bracket Assembly
(2 Screws, 2 Nuts, and
4 Washers each side)