Nortel Networks 6300 - Manual (Page 62)

Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-4
Table 3-1. ROM Monitor Commands (continued)
Command Description Use
mop [-d]
(not supported in this
release)
Displays and sets
EEPROM values
relevant to VAX/VMS
network addressing,
including the MOP
load/dump address. Loading software
from a DEC VMS
host. This
command is not
used for this
configuration of the
Remote Annex
6300.
net Executes an Ethernet
transceiver loopback
test. Checking your
Ethernet
connection.
option_key [-d] Sets or displays the
option key. Checking your
option key setting.
ping Sends ICMP
ECHO_REQUEST
datagram to a host or
gateway. Checking to see if a
host or gateway
can be reached.
ports [-d] Shows the current
status of all ports. Checking a port.
sequence [-d | <list>] Displays and edits the
load/dump interface
list. Checking or
changing the load/
dump interface list.
stats Displays current
network statistics
gathered by the ROM. Checking the
network resources.